Dynapac PL2000F, Instruction Manual

Page: 261 / 283

250
Maintenance
4812313240.pdf
2017-12-1
Water filter
Check the filter element at the end of work every
day and according to the soiling display!
The machine accessories include a second set of
water filters which makes daily replacement
possible without delay.
One water filter is under the frame, in front of the
milling drum housing on the right side of the
machine, the other one is located nearby the
conveyor suspension
The filter can also be replaced if the water tank is
not empty.
-
Close stopcock (1) (lever in horizontal
position).
-
Use the wrench provided in on-board took kit
to loosen both filters housings (2) and unscrew by
hand.
-
Remove filter elements, if necessary rinse out
housing and insert new/ cleaned filter.
-
Clean the contact surface of the discharge
and primary parts of the casing and check seal.
-
Screw both filter housing on by hand and
tighten slightly with wrench.
Check for leaks after replacing the filter!
The removed filter elements can be cleaned and if
necessary rinsed with a high pressure cleaner.
Once the machine has next been used, the
cleaned filter set can therefore be used to replace
the other filter set.
The filter casing must be emptied completely in
the case of frost in order to protect the casing from
damage.
- Close stopcock (1)
- Use the wrench provided in on-board tool kit
to loosen both filter housings (2), unscrew by
hand and shake out any water found.
Refit emptied filter casings correctly.
Fig. 1. Stopcock
2. Filter housing
Fig. 1. Stopcock
2. Filter housing