Dynapac PL2000F, Instruction Manual

Page: 249 / 283

238
Maintenance
4812313240.pdf
2017-12-1
Oil change
To drain oil, the drainage screw (2) should be in
the 6 o’clock position and 2 the filling screw (1)
should be in the 9 o’clock position.
Do not change oil when the engine is cold,
but rather directly after the transmission has
stopped.
This ensures that solid particles do not settle.
Wear protective clothing when working with
hot oil. Danger to health if oil contacts skin.
- Lower the machine on to the service
supports.
- Lift the side board and secure it.
- Ensure that the drive engine cannot be
started.
- Turn the milling drum until the mark (3) on the
drum is in the desired position.
- Remove the Allen screw (4) and screw sleeve
(5) on the drainage and inspection screw.
- Remove the inspection screw (2).
- Remove the oil drainage screw (1) and collect
draining oil.
- After all the oil has drained, properly screw
the drainage screw (1) back in.
- Fill oil using the open inspection screw until
some oil exits the hole.
- Properly reinstall the inspection screw (2).
- Properly reinstall the Allen screw (4) and
screw sleeve (5) on the drainage and inspection
screw.
Collect used oil in a suitable container and
dispose of properly.
When adding oil, ensure cleanliness.
Fig. 1. Filling screw
2. Drainage screw
3. Drum
4. Allen screw
5. Screw sleeve