Dynapac PL2000F, Instruction Manual

Page: 49 / 283

Machine description
38 4812313240.pdf
2017-12-1
The height of the strut tower is adjusted using an
integrated hydraulic cylinder which is activated by
proportional valves.
The milling depth and slope are set by means of the
two front columns. The height of each of the front
strut towers can be adjusted individually. The two
rear columns operate in tandem and therefore
adapt themselves to the appropriate machine
position. For service purposes, the rear strut towers
can also be changed over to individual adjustment
mode.
The strut tower make a large lifting height possible
so that the space required between the machine
and ground is always provided during difficult
manoeuvres such as loading.
Levelling equipment: The leveling equipment
consists of a digital controller and control display
which can be connected with combination of a tilt
sensor and various height sensors.
The leveling equipment controls the cylinders of the
front drive unit legs.
The milling depth and lateral slope required are
pre-selected and compliance is automatically
maintained with them during milling as the distance
defined to a reference surface is continually
compared and corrected.
The automatic operation can be briefly bridged and
replaced by manual control.