Best Service Routing (Category A only)
Issue 1.0 May 2003
101
Required form administration
To enable BSR polling over IP without B-channel, you must:
●
Set up the signalling group for H.323, QSIG, and NCA-TSCs
●
Set up the designated trunk group for ISDN and IP, with at least one trunk assigned.
!
Important:
!
Important:
Important:
If an IP Media Processor circuit pack is not installed, the
Trunk Group
Status
form indicates the trunk as
out-of-service
. However, status poll
signaling over D-Channel is not affected.
Administration forms for BSR polling over IP without B-channel
The forms that you must administer to enable BSR polling over IP without B-channel are
described in the following sections:
●
Pattern form
on page 101
●
Signaling Group form
on page 102
●
Trunk Group form
on page 103
●
Feature-Related System Parameters form (ISDN)
on page 106
Pattern form
Use the
display route-pattern
xx
command (where
xx
is the route pattern used by
the trunk group that supports the TSCs) to display the Pattern form. Verify that your
administration settings comply with the following requirement:
●
In the
TSC
column, set the value to
y
.
An example route-pattern form that is configured for BSR polling over IP without B-channel
is shown below.