ACU-RITE MILLPWR G2, Technical Manual

Page: 416 / 546

416 ACU-RITE Technical Manual MILLPWR
G2
Terminating the
NC program In NN_ChnProgEnd, the NC informs the PLC that an NC stop was executed
because the program end has been reached.
After the NC program has been run, the NC starts the program defined in
MP_geoCycleEnd. The trailer program is executed immediately after the NC
program.
MP_geoCycleEnd
Path/name of the trailer program for program end
Format: String
Input: Path and name of the trailing program
No entry: No trailing program is executed.
Interrupting an
NC program The PLC or NC can stop execution of the NC program. After interruption, the
NC program is continued.
During program interruption, the axes can be traversed manually.
PLC stops NC program run :
The PLC executes an NC stop with PP_ChnNcStop.
PLC operand Set
NN_ChnProgEnd
NC program end is reached
A “program end” command was executed (END-PGM,
M02 or M30).
0: NC program end not reached
1: NC program end reached
M
PLC operand Set
PP_ChnNcStop
NC stop or cycle off
0: NC stop not active
1: NC stop active
M