ACU-RITE MILLPWR G2, Technical Manual

Page: 228 / 546

228 ACU-RITE Technical Manual MILLPWR
G2
moveAfterRefFeed
400412
Feed rate for positioning after traversing the
reference mark
Format: Numerical value
Input: 10.0 to 36 000 000.0 [mm/min]
or [°/min]
Default: 6 000.0 [mm/min] or [°/min]
RUN
LEVEL3
CfgPositionLimits
Axis-specific setting of the software limit switches;
Only one range of traverse is supported at present by the TNC 320.
swLimitSwitchPos
400501
MP910
Positive software limit switch
If positive and negative software limit switches =
0, monitoring is switched off.
Format: Numeric value
Input: –100 000.0 to +100 000.0 [mm]
Default: 0.0 [mm]
RUN
LEVEL3
swLimitSwitchNeg
400502
MP920
Negative software limit switch
If positive and negative software limit switches =
0, monitoring is switched off.
Format: Numeric value
Input: –100 000.0 to +100 000.0 [mm]
Default: 0.0 [mm]
RUN
LEVEL3
lubricationDist
400503
MP4050
Path-dependent lubrication of axis
Format: Numeric value
Input: 0.000 to +100 000.000 [mm]
0: no output of lubrication pulse to
PLC
output
Default: 100.0 [mm]
RUN
LEVEL3
CfgControllerAuxil
General parameters for the position controller
driveOffLagMonitor
400601
Following-error monitoring with drive swit-
ched off
Format: Selection menu
Input:

on :
Monitoring of hanging axes is active

off :
Monitoring of hanging axes is not active
Default: off
RUN
LEVEL3
Parameter
MP number Function and input Reaction/Access