ABB ACS560, Firmware Manual

Page: 204 / 514

204 Parameters
In1 Start fwd; In2
Start rev The source selected by 20.08 Ext2 in1 source is the forward
start signal; the source selected by 20.09 Ext2 in2 source is
the reverse start signal. The state transitions of the source
bits are interpreted as follows:
3
In1P Start; In2 Stop The sources of the start and stop commands are selected by
parameters 20.08 Ext2 in1 source and 20.09 Ext2 in2 source .
The state transitions of the source bits are interpreted as
follows:
Notes:
• Parameter 20.07 Ext2 start trigger type has no effect with
this setting.
• When source 2 is 0, the Start and Stop keys on the control
panel are disabled.
4
In1P Start; In2 Stop;
In3 Dir The sources of the start and stop commands are selected by
parameters
20.08 Ext2 in1 source and 20.09 Ext2 in2 source .
The source selected by 20.10 Ext2 in3 source determines the
direction. The state transitions of the source bits are
interpreted as follows:
Notes:
• Parameter 20.07 Ext2 start trigger type has no effect with
this setting.
• When source 2 is 0, the Start and Stop keys on the control
panel are disabled.
5
No. Name/Value Description Def/FbEq16
State of source 1
( 20.08 )
State of source 2
( 20.09 )
Command
0 0 Stop
0 -> 1 ( 20.07 = Edge )
1 ( 20.07 = Level )
0 Start forward
0
0 -> 1 ( 20.07 = Edge )
1 ( 20.07 = Level )
Start reverse
1 1 Stop
State of source 1
( 20.08 )
State of source 2
( 20.09 )
Command
0 -> 1 1 Start
Any 0 Stop
State of
source 1
( 20.08 )
State of
source 2
( 20.09 )
State of
source 3
( 20.10 )
Command
0 -> 1 1 0 Start forward
0 -> 1 1 1 Start reverse
Any 0 Any Stop