Control macros 115
Notes
1)
If DI3 and DI4 are both active or inactive, the frequency/speed reference is
unchanged.
The existing frequency/speed reference is stored during stop and power down.
2)
Total load capacity of the auxiliary voltage 24V (X2:10) = 6.0 W (250 mA /
24 V). User can use this source for either of the I/O connections (DI1... DI2- RO1 or
DI3...DI6 - RO2
~
RO3).
3)
Ground the outer shield of the cable 360 degrees under the grounding clamp on the
grounding shelf for the control cables.
4)
Connected with jumpers at the factory.
5)
Input signal
6)
Output signal
7)
For R0...R2 frames only
In addition, below input is automatically set as follows:
For information on cable connection and drive operation, see
Control Connections
in
the
Hardware manual (3AXD50000044998)
.
No.
Name
(Input/Setting)
Value
Summary of Contents for ACS560
