242 Parameters
Frequency input
(when DI5 or DI6 is used as a
frequency input).
17
Control panel (ref
saved)
Panel reference (
, see page
saved by the control system for the location where the control
returns is used as the reference.
18
Control panel (ref
copied)
Panel reference (
, see page
) for
the previous control location is used as the reference when
the control location changes if the references for the two
locations are of the same type (eg
frequency/speed/torque/PID); otherwise, the actual signal is
used as the new reference.
19
Source selection (see
). -
Selects Ext1 frequency reference source 2.
For the selections, and a diagram of reference source
selection, see parameter
.
Selects a mathematical function between the reference
sources selected by parameters
and
. See diagram at
.
Ref1
is used as
frequency reference 1 as such (no function applied).
0
Add (ref1 + ref2)
The sum of the reference sources is used as frequency
reference 1.
1
Sub (ref1 - ref2)
The subtraction ([
] - [
]) of the reference sources is used as
frequency reference 1.
2
Mul (ref1 × ref2)
The multiplication of the reference sources is used as
frequency reference 1.
3
Min (ref1, ref2)
The smaller of the reference sources is used as frequency
reference 1.
4
Max (ref1, ref2)
The greater of the reference sources is used as frequency
reference 1.
5
Selects Ext2 frequency reference source 1.
Two signal sources can be defined by this parameter and
) applied to the two signals creates an
Ext2 reference. See diagram at
Zero
None.
0
AI1 scaled
).
1
No.
Name/Value
Description
Def/FbEq16
Ext1 -> Ext2
t
Reference
Ext1 reference
Ext2 reference
Active reference
Inactive reference
Ext1 -> Ext2
Ext1 reference
Ext2 reference
Active reference
t
Inactive reference
Reference
Summary of Contents for ACS560
