ABB ACS560, Firmware Manual

Page: 107 / 514

Control macros 107
Terminal sizes
• (frames R0…R8): 0.14…1.5 mm
2
(all terminals)
• Tightening torques: 0.5…0.6 N·m (0.4 lbf·ft)
Notes
1)
Current [0(4)…20 mA, R
in
< 500 ohm] or voltage [ 0(2)…10 V, R
in
> 200 kohm]
input as selected with parameter 12.15 AI1 unit selection .
2)
Current [0(4)…20 mA, R
in
= 100 ohm] or voltage [ 0(2)…10 V, R
in
> 200 kohm]
input as selected with parameter 12.25 AI2 unit selection .
3)
Total load capacity of the auxiliary voltage 24V (X2:10) = 6.0 W (250 mA /
24 V). User can use this source for either of the I/O connections (DI1... DI2- RO1 or
DI3...DI6 - RO2
~
RO3).
4)
The constant speed are set based on the combination of sources as follows:
5)
The speed reference ramp is set based on the combination of sources as follows:
6)
Connected with jumpers at the factory.
7)
Ground the outer shield of the cable 360 degrees under the grounding clamp on
the grounding shelf for the control cables.
8)
Input signal
9)
Output signal
10)
For R0...R2 frames only
For information on cable connection and drive operation, see Control Connections in
the hardware manual (3AXD50000044998) .
Source defined by
par.
22.22
Source defined by par. 22.23 Constant speed active
0 0 Set speed through AI1
1 0 Constant speed 1
DI5 Ramp set
Parameters
Vector control (default)
0 1 23.12 Acceleration time 1
23.13 Deceleration time 1
1 2 23.14 Acceleration time 2
23.15 Deceleration time 2