6-99
TI71M01D06-01EN 3rd Edition: 2012.12.01
(2) Common Setting Items
Type
Specify the calculation type if new values are assigned to #parameters. See the next section
for more information.
Changed #parameter number
Specify the #parameter whose value is to be changed on the left side.
Operator code
Specify an operator for operation/assignment. The setting is ignored in the case of direct or
indirect assignment. The following types of operators are provided.
Operator name
Operator symbol
Type of operation that can be
specified
Ad Binary
operation
Subtraction
-
Binary operation, unary operation
Multiplication *
Binary
operation
Division / Binary
operation
Remainder at division
%
Binary operation
Bit AND
&
Binary operation
Bit EXOR
^
Binary operation
Bit OR
|
Binary operation
Bit NOT
~
Unary operation
List of Operators that can be Specified
Specify registration
Select [Do not regist] if the #parameter whose value should be changed is a normal
#parameter stored in RAM. Select [Regist] if it is a #parameter to be registered in the
EEPROM. (Select [Do not regist] if the parameter is used temporarily, for instance if it is used
as a counter.)
When #parameters are registered, their values are written in the EEPROM. There is a limit on
the allowable number of times the EEPROM can be written to (approximately 1 million times).
If this limit is exceeded, the EEPROM may be damaged and the drive may not start up.
If you select "specify registration" for #parameters in the "#parameter change function" during
table operation, this limit may be exceeded depending on the pattern used.
CAUTION