6-64
TI71M01D06-01EN 3rd Edition: 2012.12.01
6.4.2 Setting Table Register
The following functions are set commonly for table data operations. They are called table
registers.
The settings should be specified for each table data.
(1) Setting of code
(2) Setting of the M function
(3) Setting of the coin waiting function
(4) Setting of the continue function
(1) M
Function
This signal is used for sequence operation, in order to coordinate the operation of other
devices interlocked with positioning operation of the direct drive motor.
The table below shows the relationship between settings of the M function and output timings
of OUT_M_EN.
If OUT_M_EN is turned ON, the table number of the table data currently being executed is
output to OUT_0_CODE.
If IN_M_ANS is turned ON, OUT_M_EN is turned off and the table data operation currently
being executed is ended. (If the continue function is set to valid, the next table data operation
is executed.)
See the next page for a sequence example.
States of Operation Register Setting and Types of M Code Executed
M function Parallel M function
Action of M function
Valid
Valid
OUT_M_EN turns ON at the same time as the start of table data operation.
Invalid
OUT_M_EN turns ON at the timing when the table data operation currently being
executed is completed.
If the coin waiting function is set to valid, OUT_M_EN turns ON after OUT_COIN
turns ON.
Invalid
Valid
The M function is not executed.
Invalid
The M function is not executed.
If OUT_M_EN is not assigned with the hard I/O assignment function, the M function is not
executed even if the M function is set to valid with the operation register at executing table
data operation.
TIP