Thermo Scientific 5030i SHARP, Инструкция по эксплуатации

Страница: 285 / 403

Thermo Fisher Scientific Model 5030 i SHARP Instruction Manual 9-1
Chapter 9
Optional Equipment
The Model 5030 i is available with the following options:
●
“ Inlet Assemblies ” on page 9-1
●
“ Sampling Tube Extensions ” on page 9-1
●
“ I/O Expansion Board Assembly ” on page 9-1
●
“ 25 Pin Terminal Board Assembly ” on page 9-1
●
“ Terminal Block and Cable Kits ” on page 9-2
●
“ Cables ” on page 9-2
●
“ Mounting Options ” on page 9-3
●
“ Roof Flange Assembly ” on page 9-8
The Model 5030 i can be used for different applications. Using different
inlet configurations (PM
10
, PM
2.5
, PM
1
Inlets), several particle size fractions
can be monitored. The main application is the measurement of PM
10
and
PM
2.5
for ambient air quality monitoring and health effect studies.
Often the most compatible way to install the Model 5030 i at air quality
monitoring sites is to collocate the inlet at the same height as other similar-
use inlets. The “
Installation ” chapter discusses specific siting criteria. In
addition to using the optional inlets, extending the sample downtube
length is necessary using a rigid sample tube.
The I/O expansion board provides six analog current output channels (0-
20 mA or 4-20 mA) and eight analog voltage inputs (0-10 V). The DB25
connector on the rear panel provides the interface for these inputs and
outputs.
The 25-pin terminal board assembly is included with the optional I/O
expansion board. Refer to “
Terminal Board PCB Assemblies ” in the
“ Installation ” chapter for information on attaching the cable to the
Inlet Assemblies
Sampling Tube
Extensions
I/O Expansion Board
Assembly
25 Pin Terminal
Board Assembly