Thermo Scientific 5030i SHARP, Инструкция по эксплуатации

Страница: 184 / 403

Preventive Maintenance
Replacement Parts
5-2 Model 5030 i SHARP Instruction Manual Thermo Fisher Scientific
See the “ Servicing ” chapter for a list of replacement parts and the associated
replacement procedures.
WARNING If the equipment is operated in a manner not specified by the
manufacturer, the protection provided by the equipment may be
impaired.
▲
Clean the outside case using a damp cloth being careful not to damage the
labels on the case.
Equipment Damage Do not use solvents or other cleaning products to
clean the outside case. ▲
The inlet assemblies can include a TSP inlet, a U.S. EPA compatible PM
10
inlet, or a Digital PM
10
or PM
2.5
inlet. Cleaning schedules and routine
maintenance of assembly components should be in accordance with a good
quality assurance plan.
In general, it is recommended that the inlet assemblies be cleaned on a
quarterly interval with mild soap solution, a thorough rinsing, and dried
with a lint free cloth. If any impaction surfaces require impactor grease, it
should be applied prior to reassembly. Furthermore, a general inspection,
and replacement as necessary, of O-rings should be done.
Equipment Damage Some internal components can be damaged by small
amounts of static electricity. A properly grounded antistatic wrist strap
must be worn while handling any internal component. For more
information about appropriate safety precautions, see the “
Servicing ”
chapter. ▲
The water collector bottle located on the PM
10
inlet should be inspected at
least every five sampling days ( Figure 5–1 ). Remove any accumulated
water, clean the interior of the bottle, inspect the seals, and replace the
bottle in the holder.
Replacement
Parts
Cleaning the Outside
Case
Cleaning the Inlets
U.S. EPA PM
10
Inlet