Thermo Scientific 5030i SHARP, Инструкция по эксплуатации

Страница: 23 / 403

Thermo Fisher Scientific Model 5030 i SHARP Instruction Manual xix
Figures
Figure 1–1. SHARP Monitor Sample Path .......................................................... 1-3
Figure 1–2. Nephelometer Sample and Zero Flow Schematic .......................... 1-5
Figure 2–1. Remove the Packing Material ......................................................... 2-3
Figure 2–2. Model 5030
i
Sampling Room Air Under Stable Conditions ........... 2-7
Figure 2–3. Model 5030
i
Side View—inches [millimeters] ............................ 2-10
Figure 2–4. Model 5030
i
Top View—inches [millimeters] ............................. 2-11
Figure 2–5. Model 5030
i
Vertical View ........................................................... 2-12
Figure 2–6. Heater Assembly ........................................................................... 2-14
Figure 2–7. Rear Panel Plumbing Schematic ................................................... 2-16
Figure 2–8. I/O Terminal Board Views ............................................................. 2-18
Figure 2–9. Pin-Out of Rear Panel Connector ................................................... 2-19
Figure 2–10. D/O Terminal Board Views .......................................................... 2-20
Figure 2–11. 25-Pin Terminal Board Views ...................................................... 2-21
Figure 3–1. Front Panel Display .......................................................................... 3-2
Figure 3–2. Front Panel Pushbuttons .................................................................. 3-2
Figure 3–3. Flowchart of Menu-Driven Firmware .............................................. 3-5
Figure 3–4. Pin-Out of Rear Panel Connector ................................................... 3-12
Figure 3–5. Common Flags ............................................................................... 3-31
Figure 3–6. Detector A Flags ............................................................................ 3-31
Figure 4–1. Differential Pressure and Vacuum Calibration Ports ...................... 4-6
Figure 5–1. U.S. EPA PM
10
Inlet .......................................................................... 5-3
Figure 5–2. European PM
10
Inlet ......................................................................... 5-4
Figure 5–3. PM
2.5
Sharp-Cut-Cyclone ................................................................. 5-5
Figure 5–4. Inspecting and Cleaning the Fan ..................................................... 5-6
Figure 5–5. Replacing the Filter Tape ................................................................ 5-8
Figure 5–6. Replacing the External Pump Exhaust Filter ................................... 5-9
Figure 6–1. Board-Level Connection Diagram - Common Electronics ............... 6-8
Figure 6–2. Board-Level Connection Diagram - Measurement System ............ 6-9
Figure 6–3. Board-Level Connection Diagram - SHARP ................................... 6-10
Figure 7–1. Properly Grounded Antistatic Wrist Strap ...................................... 7-4
Figure 7–2. Model 5030
i
Component Layout ..................................................... 7-9
Figure 7–3. SHARP Optics Component Layout ................................................. 7-10
Figure 7–4. Removing the SHARP Optics Assembly ........................................ 7-11
Figure 7–5. Removing the Measurement Case Assembly and Lowering the
Partition Panel .................................................................................................... 7-12
Figure 7–6. Replacing the Fan .......................................................................... 7-15