![background image](http://html.mh-extra.com/html/cisco/mds-9000-series/mds-9000-series_command-reference-manual_21253696.webp)
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
11-90
Cisco MDS 9000 Family Command Reference
OL-18089-01, Cisco MDS NX-OS Release 4.x
Chapter 11 I Commands
iscsi initiator idle-timeout
iscsi initiator idle-timeout
To configure the iSCSI initiator idle timeout, use the
iscsi initiator idle-timeout
command. To revert to
the default, use the
no
form of the command.
iscsi initiator idle-timeout
seconds
no iscsi initiator idle-timeout
seconds
Syntax Description
Defaults
300 seconds.
Command Modes
Configuration mode.
Command History
Usage Guidelines
When the idle timeout value is set to 0, the initiator information is cleared immediately after the last
session from the initiator terminates.
Note
This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples
The following example configures the iSCSI initiator idle timeout to 180 seconds.
switch#
config terminal
switch(config)#
iscsi initiator idle-timeout 180
The following example reverts the default value of 300 seconds.
switch#
config terminal
switch(config)#
no iscsi initiator idle-timeout 240
Related Commands
seconds
Specifies the timeout in seconds. The range is 0 to 3600.
Release
Modification
1.3
This command was introduced.
Command
Description
show iscsi global
Displays
global iSCSI configuration information.