![background image](http://html.mh-extra.com/html/cisco/mds-9000-series/mds-9000-series_command-reference-manual_212531030.webp)
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
21-92
Cisco MDS 9000 Family Command Reference
OL-18089-01, Cisco MDS NX-OS Release 4.x
Chapter 21 S Commands
switchport ingress-rate
switchport ingress-rate
To configure the port rate limit for a specified interface, use the
switchport ingress-rate
command in
interface configuration mode. Use the
no
form of the command to delete the configured switch port
information.
switchport ingress-rate
limit
no switchport ingress-rate
limit
Syntax Description
Defaults
Disabled.
Command Modes
Interface configuration submode.
Command History
Usage Guidelines
Access this command from the
switch(config-if)#
submode. This command is only available if the
following conditions are true:
•
The QoS feature is enabled using the
qos enable
command.
•
The command is issued in a Cisco MDS 9100 series switch.
Examples
The following example configures the ingress rate limit on a Fibre Channel interface.
switch#
config terminal
switch(config)#
interface fc 2/5
switch(config-if)#
switchport ingress-rate 5
Related Commands
limit
Specifies the ingress rate limit as a percentage. The range is 1 to 100.
Release
Modification
1.3(1)
This command was introduced.
Command
Description
show interface fc
Displays an interface configuration for a specified Fibre Channel interface.