S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
2-28
Cisco MDS 9000 Family Command Reference
OL-18089-02, Cisco MDS NX-OS Release 4.x
Chapter 2 A Commands
attach
attach
To connect to a specific module, use the
attach
command in EXEC mode.
attach module
slot-number
Syntax Description
Defaults
None.
Command Modes
EXEC mode.
Command History
Usage Guidelines
You can use the
attach module
command to view the standby supervisor module information, but you
cannot configure the standby supervisor module using this command.
You can also use the
attach module
command on the switching module portion of the Cisco MDS 9216
supervisor module, which resides in slot 1 of this two-slot switch.
To disconnect, use the
exit
command at the module-number# prompt, or type
$
.
to forcibly abort the
attach session.
Examples
The following example connects to the module in slot 2. After you connect to the image on the module
using the
attach module
command, the prompt changes to module-1#:
switch#
attach module 1
Attaching to module 1 ...
To exit type 'exit', to abort type '$.'
module-1#
exit
switch#
Related Commands
module
slot-numbe
r
Specifies the slot number of the module.
Release
Modification
1.0(2)
This command was introduced.
Command
Description
exit
Disconnects from the module.
show module
Displays the status of a module.
