S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
1-26
Cisco MDS 9000 Family Command Reference
OL-18089-01, Cisco MDS NX-OS Release 4.x
Chapter 1 CLI Overview
Searching and Filtering CLI Output
Parity: none
Modem In: Disable
Modem Init-String -
default : ATE0Q1&D2&C1S0=1\015
Hardware Flowcontrol: ON
Statistics: tx:35 rx:0 Register Bits:RTS|DTR
Clearing VTY Sessions
Use the
clear line
command to close a specified VTY session:
switch#
clear line Aux
Setting the Switch’s Terminal Timeout
Use the
terminal session-timeout
command in EXEC mode to configure the automatic logout time for
the current terminal session on that switch. When the time limit configured by this command is exceeded,
the switch closes that session and exits.
The syntax for this command from is
terminal session-timeout
minutes
The default is 30 minutes. You can set the
terminal session-timeout
value to 0 to disable this feature so
the terminal remains active until you choose to exit the switch. This change is not saved in the
configuration file.
switch#
terminal session-timeout 600
Specifies the terminal timeout to be 600 minutes for the current session.
Setting the Switch’s Terminal Type
Use the
terminal terminal-type
command in EXEC mode to specify the terminal type for a switch:
The syntax for this command is
terminal terminal-type
terminal-type
switch#
terminal terminal-type vt100
Specifies the terminal type. The
terminal-type
string is restricted to 80 characters and must be a valid
type (for example vt100 or xterm). If a Telnet or SSH session specifies an unknown terminal type, the
switch uses the vt100 terminal by default.
Setting the Switch’s Terminal Length
To set the terminal screen length for the current session, use the
terminal length
command in EXEC
mode. This command is specific to only the console port. Telnet and SSH sessions set the length
automatically.
The syntax for this command is
terminal length
lines
switch#
terminal length
20
Sets the screen length for the current session to 20 lines for the current terminal session. The default is
24 lines.