![background image](http://html.mh-extra.com/html/cisco/mds-9000-series/mds-9000-series_command-reference-manual_21253631.webp)
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
11-25
Cisco MDS 9000 Family Command Reference
OL-18089-01, Cisco MDS NX-OS Release 4.x
Chapter 11 I Commands
interface fc-tunnel
interface fc-tunnel
To configure a Fibre Channel tunnel and facilitate RSPAN traffic, use the
interface fc-tunnel
command.
To remove a configured tunnel or revert to factory defaults, use the
no
form of the command.
interface fc-tunnel
number
destination
ip-address
explicit-path
path-name
source
ip-address
]
no interface fc-tunnel
number
no destination
ip-address
|
no explicit-path
path-name
no source
ip-address
no interface fc-tunnel
number
Syntax Description
Defaults
None.
Command Modes
Configuration mode.
Command History
Usage Guidelines
None.
Examples
The following example initiates the FC tunnel (100) in the source switch (switch S):
switch(config)#
config terminal
switch(config)#
interface fc-tunnel 100
switch(config-if)#
The following example maps the IP address of the source switch (switch S) to the FC tunnel (100):
switchS(config-if)#
source 209.165.200.226
The following example maps the IP address of the destination switch (switch D) to the FC tunnel (100):
switch(config-if)#
destination 209.165.200.227
number
Specifies a tunnel ID range from 1 to 255.
destination
ip-address
Maps the IP address of the destination switch.
explicit-path
path-name
Specifies a name for the explicit path. Maximum length is 16 alphanumeric
characters.
source
ip-address
Maps the IP address of the source switch.
Release
Modification
1.2(1)
This command was introduced.