B&R Industries X20 System, Руководство пользователя

Страница: 287 / 2720

X20 system modules • Analog input modules • X20AI8221
X20 system User's Manual 3.10 287
Product ID X20AI8221
Conversion procedure SAR
Input filter 3rd-order low pass / cutoff frequency 1 kHz
Max. error at 25°C
Gain 0.08%
2)
Offset 0.015%
3)
Max. gain drift 0.006 %/°C
2)
Max. offset drift 0.002 %/°C
3)
Common-mode rejection
DC 70 dB
50 Hz 70 dB
Common-mode range ±12 V
Crosstalk between channels -70 dB
Non-linearity <0.025%
3)
Isolation voltage between channel and bus 500 VDC, 1 min
Operating conditions
Mounting orientation
Horizontal Yes
Vertical Yes
Installation at elevations above sea level
0 to 2000 m No limitations
>2000 m Reduction of ambient temperature by 0.5°C per 100 m
EN 60529 protection IP20
Environmental conditions
Temperature
Operation
Horizontal installation -25 to 60°C
Vertical installation -25 to 50°C
Derating -
Storage -40 to 85°C
Transport -40 to 85°C
Relative humidity
Operation 5 to 95%, non-condensing
Storage 5 to 95%, non-condensing
Transport 5 to 95%, non-condensing
Mechanical characteristics
Note Order 1x X20TB1F terminal block separately
Order 1x X20BM11 bus module separately
Spacing 12.5
+0.2
mm
Table 63: X20AI8221 - Technical data
1) To reduce power dissipation, B&R recommends bridging unused inputs on the terminals.
2) Based on the current measured value.
3) Based on the 20 V measurement range.
4.3.12.4 LED status indicators
Figure LED Color Status Description
Off No power to module
Single flash UNLINK mode
Double flash BOOT mode (during firmware update)
1)
Blinking quickly SYNC mode
Blinking slowly PREOPERATIONAL mode
Green
On RUN mode
Off No power to module or everything OK
S
Red
On Error or reset status
Off Indicates one of the following cases:
• No power to module
•
Open line
Single flash Input signal overflow or underflow
1 - 8 Green
On Analog/digital converter running, value OK
Table 64: LED status indicators
1) Depending on the configuration, a firmware update can take up to several minutes.