2.4 Stretcher Will Not Go Into the Neutral Position
Chapter 2: Troubleshooting Procedures
TranStar® PC-100/PC-200/PC-300/PC-350/PC-400/PC-450/
Page 2 - 39
PC-500/PC-550/TR-500/SG-500/OB-450/OB-550/EL-550
Series Stretcher Service Manual (man115re)
2
10. Replace any bent wireforms.
This solves the problem.
Yes
No
↓
→
Go to step 12.
11. Go to “Final Actions” on page 2-32.
12. When each brake/steer pedal is activated, each hex rod (C) rotates 45° in
either direction from neutral.
Yes
No
↓
→
Check the rocker link for proper orientation, and check the
setscrew torque of 40 + 8 in-lb (4.6 + 0.9 N·m). Adjust the rocker
link (F) orientation if necessary, and tighten the setscrew (E) to
specification. If this solves the problem, go to “Final Actions” on
page 2-32. Otherwise, continue to step 13.
13. Remove the hex rod (C) from the caster(s) (D) (refer to procedure 4.29) or
(refer to procedure 4.30). Block the stretcher with a piece of 8" x 2" x 4"
lumber. Put the 8" x 2" x 4" at each corner of the lower frame in turn, and
rotate the caster. A ratchet noise is heard when the caster is rotated.
Yes
No
↓
→
Go to step 16.
14. Replace any defective casters (refer to procedure 4.29) or (refer to
This solves the problem.
Yes
No
↓
→
Go to step 16.
15. Go to “Final Actions” on page 2-32.
16. Another part of the stretcher interferes with the brake/steer pedal.
Yes
No
↓
→
Call Hill-Rom Technical Support at (800) 445-3720.
17. Take appropriate actions to eliminate the interference.
This solves the problem.
Yes
No
↓
→
Call Hill-Rom Technical Support at (800) 445-3720.
