6-1
Section
Common Operation
133
Example: Bit memory table entry
15
10
0
[Change To] – [Address]
(start address after the change)
Address and Bit set
for [Start Range]
CIO area
Word 0
CIO area
Word 1
Bit
15
0
Address and Bit set
for [End Range]
15
0
Bit
15
0
HR area
Word 10
HR area
Word 11
Before change
After change
0000010
H0001000
0000012
H0001002
0000100
H0001006
0000110
H0001100
0000115
H0001105
Operation procedure
(1) [Tools] (menu bar)
→
[Change Address]
(2) Select the type of word before the change in the [Channel] box.
(3) Specify the range of the change by setting addresses at the [Start Range]
and [End Range] boxes.
(4) Specify the word and the address after the change in the corresponding
boxes in the [Change To] area.
(5) Set a check mark in the Change Comment check box as desired.
If a check mark is set in this check box, I/O comments appended to the ad-
dresses before the change are also appended to the addresses after the
change.
(6) Click on
.
Setting the current object status as the existing value
Register the status of the selected object as the existing value of the same kind of
object. This feature allows the status of the object, when it is registered to the
screen, to be changed, eliminating the operation steps to modify the property of
the object.
Note that the PC (PLC) address and reference memory table entry cannot be
registered as the existing value.
(1) Specify the object to be registered as the existing value (select only one ob-
ject).
(2) [Draw] (menu bar)
→
[Use as Default] (Or select [Use as Default] from pop-
up edit menu)
