Omron CS1W-CLK12-V1, Operation Manual

Page: 49 / 312

32
Data Links Procedures Section 2-1
2-1 Data Links Procedures
2-1-1 Manually Setting Data Links
When the data link mode is set for manual data link table creation, the data
link tables can be input using the Controller Link Support Software or CX-Pro-
grammer. Use the following procedure.
1,2,3... 1. Install and wire the Units.
2. Prepare for communications.
Note When using Controller Link Units in duplex operation, set the same unit num-
ber and node address for both Units.
3. Turn ON the power to the PLC.
4. Connect the Programming Device.
5. Make duplex settings for Communications Units. Create I/O tables.
Note When I/O tables for configurations with Communications Units used in duplex
operation are created, the Unit with the lower slot number will be designated
as the active Unit and the Unit with the higher slot number will be designated
as the standby Unit. To reverse this designation, edit the I/O tables offline and
transfer them to the PLC.
Contents Method Nodes Page
• Mount the Units to the
PLCs.
--- All nodes 50
• Wire the Network. --- All nodes 54
Contents Method Nodes Page
• Set the unit number.
(See note.)
Use the front rotary
switches. All nodes 67, 71
• Set the node address.
(See note.)
Use the front rotary
switches. All nodes 68, 72
Contents Method Nodes Page
Turn ON the power to
the PLC. --- All nodes ---
Contents Method Nodes Page
Connect the Program-
ming Device.
Note A Programming
Console can be
used if there is
no duplex opera-
tion.
Use the special connec-
tion cable. All nodes 22
Contents Method Nodes Page
Make duplex settings for
Communications Units
(in PLC Setup). Use the Programming
Device. Duplex nodes 173
Input the I/O tables.
(See note.) Use the SYSMAC Sup-
port Software or Pro-
gramming Console. All nodes 173