Omron CS1W-CLK12-V1, Operation Manual

Page: 247 / 312

230
Error Log Section 10-3
0116
Hex Transmission failed; CPU Bus
Unit error Command block
Bits 0 to 7:
Source node address
Bits 8 to 14:
Source Network
address
Bit 15:
OFF
Response block
Bits 0 to 7:
Destination node
address
Bits 8 to 14:
Destination Network
address
Bit 15:
ON
(1st byte: bits 8 to 15;
2nd byte, bits 0 to 7)
Check Unit and cable
connections and
clear error. No CV, CS
0117
Hex Internal buffer full Increase number of
retries or reconfig-
ure system to distrib-
ute load. No CV, CS
0118
Hex Illegal packet discarded Check for nodes
sending illegal pack-
ets. Yes CV, CS
0203
Hex EEPROM error 01 Hex:
Read error
02: Hex:
Write error 01 Hex:
Data link
tables
02 Hex: Net-
work param-
eters
03 Hex:
Routing
tables For CVM1 and CV-
series PLCs, check
that the PLC is not
protected.
Remake and set the
relevant data. If the
error occurs again for
the CVM1 and CV-
series, replace the
CPU Unit.
Yes CV
0206
Hex Number of participating nodes
decreased (local node still partic-
ipating) Network
parameters
maximum
node
address Number of
non-partici-
pating nodes Check network
parameters, node
participation, cables,
and terminating
resistance. No CV, CS
0207
Hex Number of participating nodes
decreased (local node not partic-
ipating) No CV, CS
0208
Hex Polling node changed Address of
previous
polling node Address of
new polling
node Check previous poll-
ing node. No CV, CS
0209
Hex Inconsistent network parameter 00 Hex Address of
polling node Using the Controller
Link Support Soft-
ware, check network
parameters. Yes CV, CS
020C
Hex Time out with token 00 Hex Error status
(See note 3.) Check network
parameters, node
participation, cables,
and terminating
resistance. No CV, CS
0210
Hex Communications controller send
error 00 Hex Error status
(See note 3.) Replace the Control-
ler Link Unit. Yes CV, CS
0211
Hex Duplicate address error 00 Hex Local node
address Reset so that each
node address is
used only once
within the same Net-
work. No CV, CS
0214
Hex Node address setting error Not specified Check the node
address settings and
correct them. Yes CS
Error
code
Contents Detail code Correction Written to
EEPROM Applicable
PLC
1st byte 2nd byte