101
Checking Data Link Status
Section 5-4
5-3-2
Using the Controller Link Support Software (Ver. 2.00 or Later)
and CX-Programmer
Data links can be started or stopped using commands on the Data Link Menu
of the Controller Link Support Software (Ver. 2.00). The node for which start-
ing and stopping is being specified must participate in the data links.
Using a Programming Device Connected to PLC Node
Using a Computer Node
Data links can be started or stopped from the Controller Link Support Board
on the local node.
5-3-3
Using FINS Commands
Data links can be started and stopped by sending the RUN and STOP FINS
commands from a node on the Controller Link to a node that is in the data
links.
Issuing the FINS Command from a Computer Node
Issuing the FINS Command from CVM1, CV-series, and CS-series
Data links can be stopped by sending the FINS command “STOP.” The node
to which the FINS command is issued must be participating in the data link.
5-4
Checking Data Link Status
There are two methods for checking the status of active data links:
• Check the LED indicators on the front of the Units.
• Check the data link status area.
When using Controller Link Units in duplex operation, check the data link
operating status at the active Controller Link Unit. For details on checking the
operating status for duplex operation, refer to 10-5-2 Troubleshooting for
Duplex Systems Using Indicators.
Node in data links
Start/stop data links
Controller Link Support Software (Ver. 2.00 or later)
or CX-Net (in CX-Programmer)
IBM PC/AT or
compatible
Note The Controller Link Support Software cannot be connected to a
CS-series PLC. Use the CX-Net (in CX-Programmer).
Node in data links
IBM PC/AT or
compatible
Controller Link
Support Board
Start/stop data links
Controller Link Support
Software (Ver. 2.00 or later)
FINS command:
RUN/STOP
Controller Link
Support Board
IBM PC/AT or
compatible
Node in data links
Node in data links
FINS command:
RUN/STOP
CVM1, CV or CS
Summary of Contents for CS1W-CLK12-V1
