60
Optical Wiring
Section 3-3
• Insert the connectors completely and always check that the connectors
are locked before starting operation.
• If a connector becomes disconnected while in token-bus mode, the node
will be unable to communicate with other nodes in that part of the net-
work. The network will be divided into two and communications with the
remaining nodes will be unreliable. Be sure not to remove connectors dur-
ing communications.
Even in token-ring mode, the network will be broken and communications may
be disrupted if disconnections occur at two or more places. Be sure not to
allow connectors to be disconnected during communications.
• Do not pull on the Optical Fiber Cable too forcefully.
The maximum tension that can be applied to the cord is 10 kg and the
maximum tension that can be applied to the cable is 50 kg.
Example: Connections for Duplex Operation of Communications Units
Mounting bracket
Terminal
Tension member
Higher side
Lower side
Transmission to connected side
possible (but unreliable)
Isolated
(Transmission not possible)
Cord
Cable
Summary of Contents for CS1W-CLK12-V1
