Omron CS1W-CLK12-V1, Operation Manual

Page: 245 / 312

228
Error Log Section 10-3
0101
Hex Transmission failed; local node
not in Network Command block
Bits 0 to 7:
Source node address
Bits 8 to 14:
Source Network
address
Bit 15:
OFF
Response block
Bits 0 to 7:
Destination node
address
Bits 8 to 14:
Destination Network
address
Bit 15:
ON
(1st byte: bits 8 to 15;
2nd byte, bits 0 to 7)
Refer to page 202
Troubleshooting
Using Indicators and
place the local node
into Network. No CV, CS
0103
Hex Transmission failed; retry count
exceeded Using the Controller
Link Support Soft-
ware or FINS com-
mands, run
echoback test and
check operating envi-
ronment if errors
occur. No CV, CS
0104
Hex Transmission failed; maximum
number of frames exceeded. Reduce the number
of events per com-
munications cycle or
increase the maxi-
mum number of net-
work parameter
frames. No CV, CS
0105
Hex Transmission failed; node
address incorrect Refer to 4-1 CS-
series Optical Ring
Controller Link Units
or and check node
address settings to
be sure they are
within range and
unique. No CV, CS
0106
Hex Transmission failed; redundant
node address Correct node
addresses so that
they are unique
within the same Net-
work. No CV, CS
0107
Hex Transmission failed; destination
node not in Network Refer to 10-1 Trou-
bleshooting Using
Indicators and place
destination node into
Network. No CV, CS
0108
Hex Transmission failed; specified
Unit does not exist Refer to 4-2 CVM1
and CV-series Opti-
cal Ring Controller
Link Units and check
unit address and unit
number of destina-
tion. No CV, CS
Error
code
Contents Detail code Correction Written to
EEPROM Applicable
PLC
1st byte 2nd byte