Omron CS1W-CLK12-V1, Operation Manual

Page: 129 / 312

112
Introduction Section 6-1
With the SEND, RECV, and CMND instructions, resend processing is per-
formed automatically once the number of retries has been set, so be sure
to specify a number other than “0” for the number of retries.
RECV RECV receives “m” words beginning with S (the beginning word for data
transmission at the remote node, M) to the words beginning with D (the begin-
ning word for data reception at the local node).
Note 1. When communicating with a CVM1 or CV-series PLC manufactured prior
to April 1996 on the local network, the local network address cannot be set
to “00.” Set a number other than “00” as the local network address in the
routing tables, and then specify that number.
2. With the message service, there is no guarantee that a message to a re-
mote node will reach its destination. It is always possible that the message
may be lost in transit due to noise or some other condition. When using the
message service, it is advisable to prevent this situation from occurring by
performing resend processing at the node where instructions are issued.
With the SEND, RECV, and CMND instructions, resend processing is per-
formed automatically once the number of retries has been set, so be sure
to specify a number other than “0” for the number of retries.
Remote (source) node M Local node
(
↑
)RECV(98)
S
D
C
"m" num-
ber of
send
words
D
15 0 15 0
m
S
Remote (source) node M
00 to 3E (Hex): 0 to 62 (*1)
The range of node addresses will vary for networks
other than Controller Link Networks.
C+1 0 0
C+3
0 0
Number of retries
0 to F (Hex): 0 to 15 retries
Communication port No.
0 to 7 (Hex)
0: Response required
1: Response not required
C+4
C
"m" number of send words
0000 to 03DE (Hex): 1 to 990 words
15 11 8 7 0
Remote (source) network address
00 (Hex): Local network
01 to 7F (Hex): 1 to 127
C+2
15 11 8 7 0
Remote unit address
00 (Hex):
PLC's CPU Unit
01 (Hex): Computer (user program)
10 to 1F (Hex): Unit nos. 0 to 15
E1 (Hex):
Inner Board
FE (Hex): Unit connected to network
15 11 8 7 3 0
Response monitor time
0000 (Hex): 2 s
0001 to FFFF (Hex): 0.1 to 6,553.5 s
(Unit: 0.1 s)
If the transmission speed is slow, then setting
a small value may generate an error. The
standard is approximately 4 seconds at 1
Mbps or 8 seconds at 500 Kbps.
15 0
S: Remote node beginning send word
D: Local node beginning receive word
C: Local node beginning control data word
*1 Only node addresses 1 to 32 can be specified when Optical Bus Controller Link Units/Boards (CLK11) are
combined in a network with Optical Ring Controller Link Units/Boards operating in token-bus mode.
• • •
• • •