Omron CS1W-CLK12-V1, Operation Manual

Page: 135 / 312

118
Introduction Section 6-1
For details on commands for CS-series PLCs, refer to the CS-series Program-
mable Controllers Programming Manual (W340). For details on commands for
CVM1 and CV-series PLCs, refer to the FINS Commands Reference Manual
(W227).
6-1-3 Send/Receive Data Areas
The data areas that can be used as operands in the SEND and RECV instruc-
tions depend on the PLC, as shown in the following tables. Be sure to set the
operands so that the end of the data area is not exceeded.
CS-series PLCs
Note 1. Writing is not possible to words A000 through A447 in the Auxiliary Area.
2. A maximum of thirteen banks can be used for Expansion DM. For details
on extended data memory and the number of banks, refer to the operation
manual for the PLC model that is being used.
Error data ERROR CLEAR 2101 Yes Yes
ERROR LOG READ 2102 Yes Yes
ERROR LOG CLEAR 2103 Yes Yes
File Memory FILE NAME READ 2201 Yes Yes
SINGLE FILE READ 2202 Yes Yes
SINGLE FILE WRITE 2203 Yes Yes
MEMORY CARD FOR-
MAT 2204 Yes Yes
FILE DELETE 2205 Yes Yes
VOLUME LABEL CRE-
ATE/DELETE 2206 No Yes
FILE COPY 2207 Yes Yes
FILE NAME CHANGE 2208 Yes Yes
FILE DATA CHECK 2209 No Yes
MEMORY AREA FILE
TRANSFER 220A Yes Yes
PARAMETER AREA
FILE TRANSFER 220B Yes Yes
PROGRAM AREA FILE
TRANSFER 220C Yes Yes
Forced set/reset FORCED SET/RESET 2301 Yes Yes
FORCED SET/RESET
CANCEL 2302 Yes Yes
Type of command Code CS CVM1/
CV
Area Range
CIO (IR etc.) CIO 0000 to CIO 6143
Work Area (WR) W000 to W511
Holding Area H000 to H511
Auxiliary Area A000 to A959 (See note 1.)
Timer TIM0000 to TIM4095
Counter CNT0000 to CNT4095
Data Memory D00000 to D32767
Extended Data Memory E00000 to E32767 (See note 2.)