Omron CS1W-CLK12-V1, Operation Manual

Page: 39 / 312

22
Specifications and Configurations Section 1-2
b) Ensure that the cable does not exceed its maximum bending radius.
c) The optical fiber cable’s optical characteristics and connector are the
same as those for standard connecting cables.
2. Connect Controller Link Units (CS1W-CLK52-V1) used in duplex operation
with a standard GI cable. (Use a cable no longer than the maximum allow-
able distance between standard nodes.)
1-2-7 Programming Devices
A Programming Device for the PLC, the Controller Link Support Software, or
CX-Programmer are needed to use a Controller Link Network.
Programming Device for the PLC
One of the following Programming Devices is necessary when using the auto-
matically setting data links or the message service.
The following operations are possible.
• Selecting manual or automatic setting for data links.
• Setting the data link mode to “automatic” (software switch setting).
• Starting/stopping data links (Start Bit: ON/OFF)
• Programming for the message service.
• Reading (monitoring) the network status.
Note 1. Use CX-Programmer Ver. 3.0 or later to make settings for Duplex Commu-
nications Units in CS1D Systems.
2. For details of CX-Programmer, refer to the CX-Programmer Operation
Manual.
Programming
Device
External
appearance
Model number Applicable PLCs
CX-Programmer
(for PLC) WS02-CXP @@ -EV3
(Ver 3. @ )
CS-series, C200HX/
HG/HE, CVM1-series,
and CQM1H-series
PLCs
Programming Con-
sole CQM1-PRO01-E
C200H-PRO27-E C200HX/HG/HE,
C200H/C200HS,
CQM1, and CQM1H-
series PLCs
CVM1-PRS21-EV1 CVM1 and CV-series
PLCs
Software switches (DM Area)
Controller Link
Start-up node
CPU Unit
or
Programming
Console
CX-Programmer
+
IBM PC/AT or
compatible