![background image](http://html1.mh-extra.com/html/omron/cs1w-clk12-v1/cs1w-clk12-v1_operation-manual_742356222.webp)
205
Troubleshooting Using Indicators
Section 10-1
Lit
---
---
---
---
Not lit ---
---
Cables are not
connected cor-
rectly.
Check the cable
connections are
reconnect cor-
rectly.
The node address
is larger than the
maximum node
address set in the
network parame-
ters.
Either change the
maximum node
address setting
with the Controller
Link Support Soft-
ware (Ver. 2.00 or
later) or set a node
address below the
maximum.
No other nodes
exist.
Make sure that 2 or
more nodes exist
within the Network.
No node has been
set as the polling
node.
Refer to 9-1-2 Set-
ting the Polling and
Polled Nodes s and
set the Controller
Link Unit as the
polling node.
(If both types of
optical Units are
used in a network,
use the Optical
Ring Units as
polled nodes.)
The transmission
path format setting
is different in the
polling node.
Change the set-
ting to match the
one in the polling
node and turn the
power ON again.
---
---
---
---
Flashing
Lit
Ring status:
Bit 15 ON
Error information:
Bit 15 ON
021E Hex
A break was
detected in the net-
work cable. (Net-
work operation
continues.)
Determine the
location of the
break with the
Controller Link
Support Software
(Ver. 2.00 or later)
or the ring status
word. Correct the
break. Refer to 10-
4 Locating and
Correcting Cable
Disconnections for
details.
---
---
---
---
Flashing
Not lit Ring status:
Bit 15 ON
Error information:
Bit 15 ON
021E Hex
A break was
detected in the net-
work cable. (The
Unit was out of the
network after the
error.)
Indicators
Status area
Error
code
Probable cause
Probable remedy
RUN
P/S
ERC
ERH
RING
INS
Summary of Contents for CS1W-CLK12-V1
