Omron CS1W-CLK12-V1, Operation Manual

Page: 53 / 312

36
Message Service Procedure Section 2-2
8. Start the data links.
Note Data link Start/Stop Bit (N= unit number):
CS Series: Word 0 of D 100
×
N
CVM1/CV Series: Word 0 of DM 2000 + 100
×
N
9. Stop the data links.
Note a) Data link Start/Stop Bit (N= unit number):
CS Series: Word 0 of D 100
×
N
CVM1/CV Series: Word 0 of DM 2000 + 100
×
N
b) The data links will not start if there is an error in the data link tables
in the startup node. Data links can be started and stopped using
the Controller Link Support Software.
2-2 Message Service Procedure
The following steps outline the basic procedure for using the message ser-
vice.
1,2,3... 1. Install and wire the Units.
2. Prepare for communications.
3. Turn ON the power to the PLC.
4. Connect the Programming Device.
Contents Method Nodes Page
Start the data links. Switch the Data link
Start/Stop Bit (listed
below) from OFF to ON
using either the Program-
ming Device, or the user
program. Data link startup node
(The Start Bit can be
turned ON in more then
one node to make sure
the data links start even
when the startup node is
down.)
99
Contents Method Nodes Page
Stop the data links. Switch the Data link Start/
Stop Bit (listed below)
from OFF to ON using
either the Programming
Device, or the user pro-
gram. Any node that is active in
the data link 99
Contents Remarks Page
• Mount the Units to the PLCs. --- 50
• Wire the Network. --- 54
Contents Remarks Page
• Set the unit number. --- 67, 71
• Set the node address. --- 68, 71
Contents Remarks Page
Turn ON the power to the PLC. --- ---
Contents Remarks Page
Connect the Programming Device.
Note A Programming Console can
be used if there is no duplex
operation.
--- 22