Omron CS1W-CLK12-V1, Operation Manual

Page: 67 / 312

50
Installation Section 3-2
Dimensions (Unit: mm)
3-2 Installation
The Controller Link Unit is mounted onto a CPU Backplane or Expansion CPU
Backplane for use. For detailed information on PLC installation procedures,
refer to the installation guide for the applicable PLC.
Note 1. Always turn OFF power to the PLC before mounting the Controller Link
Unit into the Backplane.
2. Be sure that all screws on the Backplane, the Bus Connection Unit, the ter-
minal block, and cables are tightened firmly. If screws work loose, a mal-
function may occur as a result of vibration.
3. Do not allow scraps of wire to enter the Unit when wiring the network.
4. A label has been placed over the upper surface of the Controller Link Unit
to prevent scraps of wire from entering the Unit. Conduct wiring and instal-
lation with this label in place. If wire scraps get into the Unit, it will malfunc-
tion. (CS-series Controller Link Units only)
5. Remove the label after wiring and installing the Controller Link Unit to pre-
vent overheating. Overheating will cause the Unit to malfunction. (CS-se-
ries Controller Link Units only)
34.5 95
250
93
103