10.7.3
Net weight ofset operation
If preset tare weight cancellation is set as [Net weight ofset operation] and zero set is
executed with the gross weight displayed, net weight ofset is not cleared.
The diference between gross weight and the net weight ofset is the net weight.
Note:
If preset tare weight cancellation is set as [Net weight ofset operation] and preset tare
weight cancellation is executed while tare weight cancellation, net weight ofset is not
executed.
Tare weight cancellation is given priority over net weight ofset.
10.8 Print command
Set print operation to manual or automatic. Manual print is used when print operation is
executed by the [F] key or by using the external control I/O.
Automatic print is used to print every time the load on the load cell is measured using a
2-pin method serial interface, BCD output interface or RS-422/485 interface.
10.8.1
Print operation status
Print operation status is selected by function F-16.
Setting range: 00 to 11
10
0
digit: Manual print operation is efective only when stable
[0]: Efective only when stable [1]: Always efective
10
1
digit: Automatic print operation
[0]: Automatic printing of [1]: Automatic printing only when stable
[00] is the default. Print using “Print input” by[F] setting or external control I/O.
10.9 Hold
This function retains various load display data, comparison results, and serial interface
data during weighing.
The hold signal is input by setting the [F] key to "hold" or by using an external control I/O.
10.9.1
HOLD operation
The HOLD operating condition is selected by function F-17.
Hold operation status can be selected from [Synchronized with Hold] or [Synchronized
with Inlow Finish].
The default is [Synchronized with Hold].
10.9.2 HOLD target
10.9.2.1
Load display value hold
Valid and invalid for load display value hold is selected by the 10
2
digit of F-18.
The default is [Valid].
Weight indicator CSD-903
10 Various operations by function data
EN-80
Minebea Intec
Summary of Contents for CSD-903
Page 243: ......
