Minebea Intec CSD-903, Operating Instructions Manual

Page: 20 / 244

5 Condition display section 2
Z-BAND Lights when a gross weight or net weight load value is less than the
set near zero
Blinks during [Z-BAND] setting and selection
F. (Coarse)
FLOW/S1
Lights when coarse low output signal is ON in sequential mode
/PRELIM2 Lights when S1 output signal is ON in comparator mode 1 or 2
Blinks during PRELIM2 setting and selection
M. (Middle)
FLOW/S2
Lights when middle low output signal is ON in sequential mode
/PRELIM1 Lights when S2 output signal is ON in comparator mode 1 or 2
Blinks during PRELIM1 setting and selection
D. (Fine) FLOW/
S3
Lights when ine low output signal is ON in sequential mode
/F. FALL (Over-
shoot)
Lights when S3 output signal is ON in comparator mode 1 or 2
Blinks during F. FALL (Overshoot) setting and selection
OVER/S4 Lights when the judgment condition is OVER in sequential mode
Lights when S4 output signal is ON in comparator mode 1 or 2
Blinks during OVER setting and selection
OK/S0 Lights when the judgment condition is OK in sequential mode
/FINAL Lights when S0 output signal is ON in comparator mode 1 or 2
Blinks during FINAL setting and selection
UNDER Lights when the judgment condition is UNDER in sequential mode
Blinks during UNDER setting and selection
FULL Lights when the judgment condition is FULL (Coarse) in sequential
mode
Blinks during FULL (Coarse) setting and selection
6
Key
Turns the display on and of. When the display is turning of, electric power is sup-
plied internally to the indicator and the load cell. The display is in stand-by while
turning of.
7
Key
Switches to function mode Reverts to former status.
8
Key
Accumulates the load value and carries up the set digit.
9
Key
Sets preset tare weight cancellation.
Carries down the set digit.
10
Key
Executes tare weight cancellation.
Raises the selected digit by 1.
Weight indicator CSD-903 3 Names and functions of parts
EN-18 Minebea Intec