Hioki 8860-50, Instruction Manual

Page: 67 / 490

3.1 Measurement Workflow
55
7
3
Chapter 3
Operatio
n Ov
erview
Display Sheet Settings*
Set on the Sheet Settings screen (p. 174).
(Make these settings to change the Waveform
screen layout)
See
• To optionally assign measurement data to Sheets
(p. 175)
• To change Sheet names (p. 177)
• For X-Y composite measurements (p. 187)
Screen Layout Settings (p. 177)
Split-Screen Number and Pattern Settings
(p. 178)
Displayed Channel Settings (p. 181)
Save Settings
Set on the Save Settings screen (p. 261).
(Make these settings to save data)
To save automatically while measuring, be sure to make
these settings before starting.
See
• About saving methods (p. 267)
Auto or Manual Save Settings
Save Contents Setting
Print Settings
Set on the Print Settings screen (p. 313).
(Make these settings when you want to print data.)
To print automatically while measuring, be sure to make
these settings before starting.
See
Using an external printer (p. 315)
Auto or Manual Print Settings
Print Content Settings
Start Measurement
Press the
START
key (p. 76).
Data Acquisition
Save & Print (when Auto enabled)
End of Measurement
Press the
STOP
key to stop (p. 76).
If [Single] trigger mode is selected, recording stops
automatically after acquiring the specified data length.
Press twice to stop immediately.
Data Analysis
Analysis on the waveform screen (p. 191).
See
(Memory Function)
• To calculate numerical values (Analysis and Communica-
tion Supplement )
• To calculate waveform data ( Analysis and Communication
Supplement )
• For X-Y composite (p. 187)
• To search waveform data (p. 222)
• To perform FFT calculation ( Analysis and Communication
Supplement )
Waveform Scrolling (p. 192)
Cursor Measurements (p. 202)
Magnification/Compression and Zoom
(p. 211)