Hioki 8860-50, Instruction Manual

Page: 258 / 490

9.3 Pre-Measurement Settings
246
Starting and Ending Recording
Press the START key.
The green LED lights as measurement starts.
After recording for the set recording length, data for the
whole waveform is displayed. Measurement waveform
data is saved directly to the save destination.
If the trigger mode is [Single], measurement stops.
If the trigger mode is [Repeat], measurement restarts.
During measurement, if the [Buffer (buffer usage sta-
tus)], which is the memory used for temporary storage,
exceeds 30%, waveform drawing is suspended to
yield precedence to the saving process. Waveform
drawing resumes when buffer usage subsequently
drops below 5%.
When measurement ends, the waveform is displayed normally.
To stop measurement
Press the STOP key.
Pressing the STOP key once causes recording to stop after the set re-
cording length has been acquired.
Pressing the STOP key twice stops recording immediately.
Depending on the timebase and recording length, maximum and mini-
mum values at the end of the whole waveform may not be recorded.
Also, when recording is interrupted, whole waveform data does not in-
clude the last maximum and minimum value data. Such cases can be
confirmed by loading the measurement waveform.
To save and print when finished measuring
See "11.3.5 Setting Manual Save (SAVE Key Output)" (p. 278)
"12.4 Making Manual Print (PRINT Key Output) Settings" (p.
319)
Screen While Measuring