Hioki 8860-50, Instruction Manual

Page: 69 / 490

3.1 Measurement Workflow
57
7
3
Chapter 3
Operatio
n Ov
erview
3.1.2 Logic Waveform Recording
To simultaneously record logic waveforms, see also "3.1.1 Analog Waveform Recording" (p. 53).
Procedure (asterisks (*) indicate settings that
can be changed while measuring)
Overview and references
Installation & Connection
Connect the logic probes.
See "2.6 Connecting Logic Probes" in the Input Module Guide
Power On
Measurement
Configuration Settings*
Set on the Status Settings screen.
Timebase Setting (p. 90)
Recording Length Setting (p. 97)
Set Channels to Use (p. 86)
Enable (turn on) the channels to use (With Memory function).
Input Channel
Settings*
Set on the [Logic] page of the Channel Settings
screen.
Set Waveform Display On/Off (p. 184)
Set waveform display for each channel probe on or off.
(Default setting: Off)
Set Waveform Display Color (p. 184)
Set as occasion demands.
Trigger Settings*
Set on the [Logic] page of the Trigger Settings
screen (p. 135).
(Make these settings to record a specific waveform, such as an anom-
aly: enable triggering)
Trigger Mode Setting (p. 138)
Trigger Criteria Settings (p. 139)
Logic Trigger Settings (p. 159)
Display Sheet Settings*
Set on the [Logic] page of the Sheet Settings screen.
Set Display or Non-Display (p. 184)
Enable (set On) the channels to be displayed.
(Default setting: On)
Set Display Positions (p. 185)
Set for each channel as occasion demands.
(Default settings: Position 1, 2, … beginning with Lch A)
Set Display Height (vertically) (p. 186)
Set as occasion demands.
(Default setting: Normal)
From here, proceed the same as for analog channels. Refer to "Save Settings" (p. 55).