Hioki 8860-50, Instruction Manual

Page: 254 / 490

9.3 Pre-Measurement Settings
242
Make the settings required for measurement, such as the save destination and
channels to use.
9.3 Pre-Measurement Settings
Settings required before measurement:
Save destination and channel(s) to use
Because the timebase and recording length may be limited by the save
destination and number of channels used, always check these settings
before measuring.
Function Selection (Waveform or Settings Screen)
Operating Key Procedure
1
CURSOR
Move to the function menu (at the top left).
2
F4
Select [REALTIME] (Real-time saving function).
The operating function can be selected from the pull-
down menu (p. 81).
Function Menu
2
: On
: Off
Operating Key Procedure
1
SHEET/PAGE
Select the [Use Ch] page.
2
Select the channels for measurement (analog/logic in-
puts).
CURSOR
Move the highlight cursor to a channel to be set.
F1 to F8
Select either choice.
With the Real-Time Saving function, all enabled
channels (those with 'On' checked) are saved, re-
gardless of whether their waveforms are dis-
played.
See: "Chapter 7 Waveform Display Settings" (p. 169)
Off No measurement
On Use for measurement (default setting)
Setting Channels to Use
To open the screen: Press the
SET
key

Select with the
SUB MENU
keys

Status Settings screen
1
Input Module and Channel Nos.
Logic channels
Enables (sets ‘On’) all channels.