Hioki 8860-50, Instruction Manual

Page: 389 / 490

14.1 Connecting External Control Terminals
377
14
Chapter 14
External Control
Connecting the SYNC.OUT Jack and the EXT.SMPL Jack (BNC connector)
Connect the BNC plug of the connection cord to
the BNC jack on the instrument side.
Align the slots on the BNC plug with the guide pins on
the instrument-side jack, then push and twist the plug
clockwise until it locks.
Disconnecting BNC connectors
Twist the BNC plug counterclockwise and pull it out.
Lock
Instrument-side
guide pins
BNC plug slots
Connecting External I/O Terminals (Connector Blocks)
Cables to connect
Single strand
Multi-strand
10 mm
Connection procedure
1
2
3
• Recommended cables:
single strand diameter 0.65 mm (AWG22),
multi-strand 0.32 mm
2
(AWG22)
• Usable cables:
Single strand diameter 0.32 to 0.65 mm (AWG28 to 22),
Multi-strand 0.08 to 0.32 mm
2
(AWG28 to 22)
Strand diameter 0.12 mm or greater
• Standard insulation stripping length: 9 to10 mm
• Button operation specified tool: Flat-blade screwdriver
(tip width 2.6 mm)
1
Push in the button on the connector with a flat-
blade screwdriver or other tool.
2
With the button held in, insert the cable into the
cable connection hole.
3
Release the button.
The cable is locked.