Hioki 8860-50, Instruction Manual

Page: 199 / 490

7.4 Composite Waveforms (X-Y Waveforms)
187
7
Chap
ter 7 W
ave
form
Display Se
ttings
This applies to the Memory function only.
Any channels can be displayed as a composite during or after measurement. To
make a composite while measuring, measurement configuration settings and X-
Y composite have to be set before starting measurement. Refer to the appropri-
ate chapters for measurement configuration settings. This section describes the
composite waveform settings.
7.4 Composite Waveforms (X-Y Waveforms)
1
2
3
4
X-Y Waveforms
To open the screen: Press the
SET
key

Select with the
SUB MENU
keys

Sheet Settings screen
See Screen Layout (p. 174)
Composite setting is available both before and after measurement.
Operating Key Procedure
1
Set the Display Type.
CURSOR Move the cursor to the [Display Type] item.
F1 to F8 Select either choice.
2
Set Split-Screen display (p. 178).
CURSOR Move the cursor to the [Split-Screen] item.
F1 to F8 Select the number of Graphs. (Available choices
depend on the Display Type setting.)
3
Set the Composite Area.
CURSOR Move the cursor to the [Area] X-Y Composite
item.
F1 to F8 Select either choice.
4
Set line interpolation (as occasion demands).
CURSOR Move the cursor to the [Dot-Line] item.
F1 to F8 Select either choice.
X-Y Comp
Displays X-Y waveforms.
Wave & X-Y
Displays both X-Y composite and
analog waveforms.
Whole
Use the whole range for the composite
waveform. (default setting) (default setting)
A-B
Use the range specified by the cursors.
Procedure to specify a range with A/B cur-
sors:(p. 200)
Dots
Do not interpolate straight lines. Input sig-
nals (sampling data) are displayed and re-
corded as is.
Line
Interpolate straight lines. This can improve
display visibility, although the display
speed is slower than Dots display.
(default setting)
"Making Partial Composites" (p. 189)
To make a partial composite while mea-
suring, first acquire waveforms and
specify the waveform range with A/B
cursors.