Hioki 8860-50, Instruction Manual

Page: 201 / 490

7.4 Composite Waveforms (X-Y Waveforms)
189
7
Chap
ter 7 W
ave
form
Display Se
ttings
Making Partial
Composites
Make a partial composite after specifying the composite range within normal
waveforms using the A/B cursors.
See "8.7 Specifying a Waveform Range" (p. 200), "8.8 Cursor Values" (p. 202)
Method 1
View the normal waveform display and the partial composite waveform on
a separate sheet
Set the Sheet Settings screen as follows:
• Sheet 1 (S1)
Display Type: [Waveform]
• Sheet 2 (S2)
Display Type: [X-Y Comp] or [Wave & X-Y]
Composite Area: [A-B]
Also make the required settings for the X-Y composite such as composite
channel selections.
Display Sheet 1 (S1) on the Waveform screen, and specify the waveform range
for the composite using the
[Vertical] or [Trace] mode of the A/B cursors. The
sheet displayed on the Waveform screen can be switched by the SHEET/PAGE
keys.
The composite range can be changed from Sheet 1.
Making X-Y composite settings from a dialog
Move the cursor to the [No.] column to be set, and select F1 [All Settings] .
A dialog appears. Move the cursor to each item and select with the F keys.
To reset graph settings
Move the cursor to the [Reset Graphs] button, and select F1 [Reset Graphs] .
Graph numbers are reassigned sequentially from the top of the setting column.
F1
• Horizontal cursors cannot be used to specify the range for partial composites.
• When one cursor is used, the X-Y composite range is from the cursor to the
end of the waveform.
Sheet 1 (S1)
Normal Waveform
Sheet 2 (S2)
Partial Composite Waveform