Hioki 8860-50, Instruction Manual

Page: 193 / 490

7.2 Setting the Screen Layout of the Waveform Screen (Sheet Settings Screen)
181
7
Chap
ter 7 W
ave
form
Display Se
ttings
The default setting assigns channels in the order of input module installation.
However, with the Memory function or Real-time saving function, only those
channels enabled for use [On] can be assigned.
See "4.2.1 Selecting Channels to Use" (p. 86)
7.2.6 Assigning Display Channels to Graphs (Analog
Channels)
Operating Key Procedure
1
Select the channels to display on the Sheet.
SHEET/PAGE Select the [Analog] page.
CURSOR Move the highlight cursor to the No. to set, and
then to the
[Ch] column.
F1 to F8 Select the channel number of the unit (module) to
display on the Sheet.
To not display the channel, select
F3 [Off] .
2
Select the display graph (when Split-Screen is set to
[2 Graphs] or more).
CURSOR Move the cursor to the [Graph] column.
F1 to F8 Select the graph number in which to display.
Verify the pattern display for the graph number.
1
2
Indicates the input type for selected chan-
nels.
Analog Channel Assignment
To open the screen: Press the
SET
key

Select with the
SUB MENU
keys

Sheet Settings screen
See Screen Layout (p. 174)
Setting from a dialog
Move the cursor to the
[No.]
column of the channel to be set, and select F1 [All
Settings] . A dialog appears. Set each item, then select the [Close] button.
If “Storage Off” appears
A selected channel is disabled ( [Off] ) on the [Use Ch] page of the Status Settings
screen. To display, set the channel to [On] and measure again.
If “Display Off” appears
Waveform display setting on the Channel Settings screen is disabled ( [Off] ). To
display the waveform on the Waveform screen, set it to [On] .