Club Car Carryall 300 2021, Maintenance And Service Manual

Page: 286 / 596

16
Motor Installation ELECTRIC VEHICLE - MOTOR
6. Insert the mounting bolts through the spring shackles and the bushings in the leaf spring eyes and install lock
nuts. Tighten the bolts to 23 ft·lb (31 N·m).
See Multi-Leaf Spring Installation, Section 9, Page 9-5.
7. Install the shock absorbers. Tighten nut until rubber bushing expands to the diameter of the cup washer.
8. If removed, install wheels and finger tighten the lug nuts.
9. Lift vehicle and remove jack stands. Lower vehicle to the floor and tighten lug nuts, using a crisscross pattern, to
65 ft·lb (88 N·m).
10. Connect the batteries. See Connect the Batteries – Electric Vehicles, Section 1, Page 1-5.
11. Place the Run/Tow switch in the RUN position.
12. Inspect the vehicle for proper operation. See following WARNING.
WARNING
• Make sure that the vehicle operates in the forward direction when the Forward/Neutral/Reverse control
(FNR) is in the F position.
• Make sure that the vehicle operates in the reverse direction when the Forward/Neutral/Reverse
control (FNR) is in the REVERSE position. The reverse buzzer will sound as a warning when the
Forward/Neutral/Reverse control (FNR) is in REVERSE.
• Make sure that the vehicle does not operate when the Forward/Reverse switch is in the NEUTRAL
position.
2
3
1
1313
Figure 16-25 EJ8–4001A Motor Mounting Bolts and
Tightening Sequence
Page 16-18 2021 Carryall 300 Maintenance and Service Manual