Club Car Carryall 300 2021, Maintenance And Service Manual

Page: 341 / 596

GASOLINE VEHICLE - TROUBLESHOOTING
AND ELECTRICAL SYSTEM Test Procedures
18
TEST PROCEDURE 29 – Solenoid - Key-Start Vehicles Only
See General Warnings on page 1-1.
NOTE: This is a resistance and voltage test.
1. If necessary, see Testing Basics.
2. Remove the electrical component box cover (1) (Figure 18-27) .
10
10
10
1
4
5
6
3
2
2
3025B
Figure 18-27 Solenoid Wires
3. Make sure that the wires are connected correctly and are tight. If they are not, rewire or tighten as necessary.
4. Coil Side: Check the resistance across the small posts (2) of the solenoid (3). The reading should be 14 to 16
ohms. If the reading is not within limits, replace the solenoid.
5. Contact Side: Remove the wires (4,5,6) from the large post of the solenoid. Do not allow the wires to touch the
frame or other components of the vehicle. Cover the other large post.
6.
6.1. Set the Forward/Neutral/Reverse control (FNR) to N.
6.2. Set the Maintenance/Operate switch to MAINTENANCE.
6.3. Check the voltage between the empty large post (1) and ground (Figure 18-7, Page 18-18) .
2021 Carryall 300 Maintenance and Service Manual Page 18-43