Club Car Carryall 300 2021, Maintenance And Service Manual

Page: 39 / 596

BODY AND TRIM Front Body
4
2846D
Figure 4-2 Front Cowl
GRILLE REMOVAL
1. Park vehicle and chock the tires.
2. Disconnect the batteries. See Disconnect the Batteries – Electric Vehicles, Section 1, Page 1-5.
See Disconnect the Battery- Gasoline Vehicles on page 1-4.
3. Remove HD bumper (if equipped). See Brushguard Removal, Section 4, Page 4-3.
4. Remove cowl. See Cowl Removal on page 4-4.
5. Loosen and remove the two M6 self-tapping fasteners (1) at the top of grille (7). (Figure 4-3, Page 4-7) .
6. Loosen and remove the two lower left and right side bolts (1 and 7) that attach the grille and plastic bumper (6).
7. Remove charger receptacle (if equipped) by removing the three screws that attach the receptacle or disconnect
connector (quick connect)
GRILLE INSTALLATION
1. Connect the charger receptacle or connector (quick connect).
2. Install, but do not tighten upper M6 screws. (Do not tighten screws until plastic bumper is installed).
3. Lower grille holes are shared with the front bumper, ensure lower bumper screws are attached first then install
grille.
4. Line up upper and lower bolt holes.
2021 Carryall 300 Maintenance and Service Manual Page 4-5