Club Car Carryall 300 2021, Maintenance And Service Manual

Page: 52 / 596

4
Rear Triangle Reflector BODY AND TRIM
REAR TRIANGLE REFLECTOR
Figure 4-9
REAR TRIANGLE REFLECTOR REMOVAL
1. Disable the vehicle.
2. Remove the four rivets (1) and washers (2) (Figure 4-9) . Discard the rivets.
3. Remove the rear triangle reflector (3).
REAR TRIANGLE REFLECTOR INSTALLATION
1. If the rear triangle reflector has never been installed:
1.1. Put the triangle plate (1) on the tail skirt (2) (Figure 4-9) .
NOTE: Make sure to laterally align the triangle plate on the center-line of the tail skirt.
Make sure to vertically align the lower edge of the triangle plate with the lower part of the flat vertical surface.
1.2. Use the four holes in the triangle plate as a template. Match drill four 0.20 inch (5.08 mm) holes through
the tail skirt. Deburr all holes drilled and remove unwanted material.
2. Attach the triangle plate to the tail skirt with four washers (3) and four new rivets (4).
3. Make sure that the air and surface temperatures are above 60° F (16° C). Temperatures above 60° F (16°
C) result in a good bond.
4. Clean the triangle plate surface area with soap and water. Make sure to remove all debris (dirt, grease, and oils).
5. Dry the area fully with a lint free cloth.
Page 4-18 2021 Carryall 300 Maintenance and Service Manual