Club Car Carryall 300 2021, Maintenance And Service Manual

Page: 409 / 596

GASOLINE VEHICLE - FUEL SYSTEM Engine Control Linkages
21
1
2
3
3
539
Figure 21-1 Accelerator Rod
1345
Figure 21-2 Accelerator Rod – Pull Spring Release to
Attach (Bottom View)
Accelerator Rod Installation and Adjustment
1. Before installing the accelerator rod, adjust accelerator pedal position. See Pedal Group Adjustment –
Gasoline Vehicles in the Accelerator and Brake Pedal Group Section.
2. Install the ball joint (1) on the ball stud (2) at the accelerator pedal (Figure 21-1, Page 21-3) .
3. Access the engine compartment.
4. Remove the electrical component box screw and cover (Figure 21-3, Page 21-4) .
5. Adjust length of accelerator rod. With the ball joint jam nuts (3) loose (Figure 21-1, Page 21-3) , adjust the length
of the rod to obtain an accelerator cable cam position of 7° as shown (Figure 21-3, Page 21-4) . See following
CAUTION.
CAUTION
• Be sure that approximately an equal number of threads are exposed at each end of the accelerator rod.
6. Install the accelerator rod on the bell crank ball joint on the electrical component box (Figure 21-2, Page 21-3) .
See following CAUTION.
CAUTION
• Inspect the limit switches inside the electrical component box. If a limit switch lever is bent, replace
the switch.
2021 Carryall 300 Maintenance and Service Manual Page 21-3