Club Car Carryall 300 2021, Maintenance And Service Manual

Page: 336 / 596

18
Test Procedures
GASOLINE VEHICLE - TROUBLESHOOTING
AND ELECTRICAL SYSTEM
TEST PROCEDURE 23 – Headlight Switch
See General Warnings on page 1-1.
NOTE: The headlight circuit is protected by the 20-amp fuse. Check the fuse before this procedure is performed.
See Test Procedure 2 – Fuses on page 18-11.
This is a voltage test.
1. If necessary, see Testing Basics.
2. Check the 20 amp fuse that protects the headlight circuit.
2.1. If the fuse is bad, replace the fuse.
2.2. If the fuse is good, go to the next step.
3. Remove the instrument panel.
4. Set the multimeter set to 20 VDC.
5. Put alligator clips on the multimeter probes.
6. Connect the red (+) probe to terminal of the headlight switch where the green/white wire is connected..
7. Connect the black (–) probe of the multimeter to ground.
8. Set the headlight switch to OFF.
8.1. If there is voltage, replace the headlight switch.
8.2. If there is no voltage, go to the next step.
9. Set the headlight switch to ON.
9.1. If there is battery voltage, the headlight switch is good.
9.2. If there is no voltage, check the associated wiring and 10 amp fuse.
9.2.1. If the wires and fuse show continuity and the readings are still incorrect, replace the headlight switch.
Page 18-38 2021 Carryall 300 Maintenance and Service Manual